Small size air pressure swing-arm manipulator BRTP08WSS0PC

One axis servo manipulator BRTP08WSS0PC

Short Description

BRTP08WSS0PC series applies to all types of horizontal injection machines of 150T-250T for take-out products. The up and down arm is a single/double sectional type.

Main Specification

Recommended I.M.M (ton): 150T-250T

Vertical Stroke (mm): 850

Traverse Stroke (mm): /

Max loading (kg): 2

Weight (kg): 60

Send email to us

Product Detail

Product Tags

10000

Product Introduction

BRTP08WSS0PC series applies to all types of horizontal injection machines of 150T-250T for take-out products. The up and down arm is a single/double sectional type. The up and down action, drawing part, screwing out, and screwing in of them is driven by air pressure, with high speed and high efficiency. After installing this robot, productivity will be increased by 10-30%.

Accurate Positioning

Fast

Long Service Life

Low Failure Rate

Reduce Labor

Telecommunication

Basic Parameters

Power Source (KVA)	Recommended I.M.M (ton)	Traverse Driven	Model of EOAT
1.27	150T-250T	Cylinder drive	zero suction zero fixture
Traverse Stroke (mm)	Crosswise Stroke (mm)	Vertical Stroke (mm)	Max.loading (kg)
/	300	850	2
Dry Take Out Time (sec)	Dry Cycle Time (sec)	Swing Angle (degree)	Air Consumption (NI/cycle)
2	6	30-90	3
Weight(kg)
60

Model representation: W: Telescopic type. D: Product arm +runner arm. S5: Five-axis driven by AC Servo Motor( Traverse-axis、Vertical-axis + Crosswise-axis).
The above-mentioned cycle time are the results of our company’s internal test standard. In the actual application process of the machine, they will vary according to the actual operation.

Trajectory Chart

A	B	C	D	E	F	G	H
1205	1031	523	370	972	619	102	300
I	J	K
180	45°	90°

No further notice if the specification and appearance are changed due to improvement and other reasons. Thank you for your understanding.

Recommended Industries

Auto Mode

Press “auto” key in Auto mode, system turn into Auto mode, Robot int automatic state of preparation, Page as follows:

In the state of preparation, You can run the auto actions when press the START key, Page as follows:

CurrMold: Mode number of the currently selected, Running program in accordance with this model number int the AUTO mode.
CyclTime: Record the current automatic cycle with time. ProdSet: The plans of products number, It will alarm when the actual output reaches the set production.
FetTime: In the AUTO run-time, Each automatic cycle time from prohibit the injection switch-mode to allow
ActFini: The number of complete production
ActTime: The actual time of action.
CurrAct: The executing action.
Auto run-time, press “TIME” key to enter the page to modify the time parameters, and can enter MONITOR, INFO page to view I/O signal and INFO record, Press automatic key to return to auto page.
When fetch failed alarm accurs in AUTO mode, You can press Auto key (or open safe door) to close alarm and continue. Or press the stop button to back to the origin status, and exit auto mode