One axis plastic molding injection manipulator robot BRTB08WDS1P0F0

One axis servo manipulator BRTB08WDS1P0F0

Short Description

BRTB08WDS1P0/F0 is telescopic type, with a product arm and runner’s arm, for two plate or three plate mold products take out. The traverse axis is driven by an AC servo motor.

Main Specification

Recommended I.M.M (ton): 120T-250T

Vertical Stroke (mm): 800

Traverse Stroke (mm): 1250

Max loading (kg): 3

Weight (kg): 198

Send email to us

Product Detail

Product Tags

20000

Product Introduction

BRTB06WDS1P0/F0 traversing robot arm applies to all types of horizontal injection machine ranges of 120T-250T for take-out products and sprue. Single-axis drive control integrated control system: fewer signal lines, long-distance communication, good expansion performance, strong anti-interference ability, high accuracy of repeated positioning, can control multiple axes at the same time, simple equipment maintenance, and less failure rate.

Accurate Positioning

Fast

Long Service Life

Low Failure Rate

Reduce Labor

Telecommunication

Basic Parameters

Power Source (KVA)	Recommended I.M.M (ton)	Traverse Driven	Model of EOAT
1.69	120T-250T	AC Servo motor	One suction one fixture
Traverse Stroke (mm)	Crosswise Stroke (mm)	Vertical Stroke (mm)	Max.loading (kg)
1250	P:300-R:125	800	3
Dry Take Out Time (sec)	Dry Cycle Time (sec)	Air Consumption (NI/cycle)	Weight (kg)
1.7	6.49	3.5	198

Model representation: W: Telescopic type. D: Product arm +runner arm. S5: Five-axis driven by AC Servo Motor( Traverse-axis、Vertical-axis + Crosswise-axis).
The above-mentioned cycle time are the results of our company’s internal test standard. In the actual application process of the machine, they will vary according to the actual operation.

Trajectory Chart

A	B	C	D	E	F	G	H
1340	2044	800	388	1250	354	165	210
I	J	K	L	M	N	O
135	475	520	1190	225	520	1033

No further notice if the specification and appearance are changed due to improvement and other reasons. Thank you for your understanding.

Recommended Industries

One axis servo manipulator BRTB08WDS1P0F0 System Installation

1) Wiring work must be performed by a professional electrician.
2) Make sure the power is disconnected before starting the operation.
3) Please install it on flame-retardant materials such as metal and keep away from combustible materials.
4) It must be safely grounded when used.
5) If the external power supply is abnormal, the control system will fail. In order to make the whole system work safely, please be sure to set the safety circuit outside the control system. Injection molding multi axis manipulator BORUNTE Injection Molding Control System Multi-axis 269.
6) Before installation, wiring, operation and maintenance, the operator must be familiar with the content of this manual. It is also necessary to fully understand the relevant mechanical and electronic knowledge and all related safety precautions.
7) The electric control box for installation of the controller should be well ventilated, oil-proof and dust-proof. If the electric control box is airtight, the temperature of the controller is likely to be too high, which will affect the normal work. Therefore, an exhaust fan must be installed. The suitable temperature in the electric control box is below 50°C. Do not use it in places with condensation and freezing.
8) The controller should not be installed too close to the contactor, transformer and other AC accessories to avoid unnecessary surge interference. Caution: Improper handling may cause hazards, including personal injury or machine accidents.