Five axis long vertical stroke manipulator arm BRTN17WSS5PC,FC

Five axis servo manipulator BRTN17WSS5PC,FC

Short Description

Accurate positioning, high speed, long life, and low failure rate. After installing the manipulator can increase production capacity (10-30%) and will reduce the defective rate of products, ensure the safety of operators, and reduce manpower.

Main Specification

Recommended I.M.M (ton): 600T-1300T

Vertical Stroke (mm): 1700

Traverse Stroke (mm): 2510

Max loading (kg): 20

Weight (kg): 585

Send email to us

Product Detail

Product Tags

45000

Product Introduction

BRTN17WSS5PC/FC series applies to various types of 600T-1300T plastic injection molding machines, five-axis AC servo drive, with AC servo axis on the wrist. The rotation angle of the A-axis: 360°, and the rotation angle of the C-axis:180°, which can locate and adjust the angle of the fixture freely. Both of them have a long life, high accuracy, low failure rate, and simple maintenance. It is mainly used for quick injection or complex angle injection, especially suitable for long shape products such as automotive products, washing machines, and household appliances. Five-axis driver and controller integrated system: fewer signal lines, long-distance communication, good expansion performance, strong anti-interference ability, high accuracy of repeated positioning, can simultaneously control multiple axes, simple equipment maintenance, and low failure rate.

Accurate Positioning

Fast

Long Service Life

Low Failure Rate

Reduce Labor

Telecommunication

Basic Parameters

Power Source (kVA)	Recommended I.M.M (ton)	Traverse Driven	Model of EOAT
4.23	600T-1300T	AC Servo motor	four suctions two fixtures
Traverse Stroke (mm)	Crosswise Stroke (mm)	Vertical Stroke (mm)	Max.loading (kg)
2510	1415	1700	20
Dry Take Out Time (sec)	Dry Cycle Time (sec)	Air Consumption (NI/cycle)	Weight (kg)
4.45	13.32	15	585

Model representation: W:Telescopic type. S:Product arm. S5: Five-axis driven by AC Servo Motor (Traverse-axis、Vertical-axis+Crosswise-axis).
The above-mentioned cycle time are the results of our company’s internal test standard. In the actual application process of the machine, they will vary according to the actual operation.

Trajectory Chart

A	B	C	D	E	F	G
2067	3552	1700	541	2510	/	173
H	I	J	K	L	M	N
/	/	1835	/	395	435	1420
O
1597

No further notice if the specification and appearance are changed due to improvement and other reasons. Thank you for your understanding.

Product Application Range

The device is excellent for extracting the completed product and nozzle from a 600T to 1300T horizontal injection molding machine. It’s suitable for removing medium-sized injection molding items such as coil winding tubes, integrated circuit shells, capacitor shells, transformer shells, TV accessories such as tuners, switches, and timer shells, and other soft rubber components.

Operation Mode of Manipulator

The manipulator has three operational modes: Manual, Stop, and Auto. Turning the state switch to the left enters Manual mode, allowing the operator to operate the manipulator manually; turning the state switch to the middle enters Stop mode, halting all operations except the origin reset and parameter setting; and turning the state switch to the right and pressing the “Start” button once enters Auto mode.

Regularly Check

Regularly check the tightness of nuts and bolts:
One of the primary causes of manipulator failure is the relaxation of nuts and bolts due to the lengthy period of vigorous operation.
1.Tighten the limit switch mounting nuts at the transverse portion, the drawing part, and the front and side arms.
2. Check the tightness of the relay point position terminal in the terminal box between the moving body part and the control box.
3. Securing each brake device.
4. Whether there are any loose bolts that might cause damage to other equipment.